| Exporter, Wholesale, Manufacturer | |
| Tehran_North |  |
| +989122003350 | |
- Price :negotiated
Elevator button , Iran
An elevator push button is a user interface component for sending hall call or floor selection commands to the control system. The operating control voltage is typically defined between 12 and 24 volts DC. Current consumption per button is generally below 50 milliamperes. The enclosure protection rating is IP40 in standard models and up to IP65 for special environments. The panel material is stainless steel with thickness from 0.8 to 1.5 millimeters. Mechanical life of the push mechanism is guaranteed for at least 1 million operating cycles. Standard mounting hole diameter for round buttons is 22 or 30 millimeters.
The structure consists of a microswitch or capacitive touch sensor combined with an LED status indicator circuit. LED brightness is adjusted between 50 and 150 candela per square meter. Electrical contact resistance is typically measured below 50 milliohms. Permissible operating temperature ranges from minus 10 to plus 60 degrees Celsius. Electrical safety standards comply with EN 81 and EN 60947 requirements. Installation can be flush or surface mounted with dimensional tolerance less than ±0.5 millimeters.You can order and buy Elevator button from Iran by contacting us through whatsaap and email.
WEBSITE: Elevator button Iran
Safety Standards for Elevator Push Buttons in iran
Elevator push button safety standards are defined based on electrical, mechanical, and ergonomic requirements. According to EN 81-20 and EN 81-70, buttons must be installed at a height between 900 and 1100 mm from the floor. The allowable operating force is typically set between 2.5 and 5 newtons to prevent accidental activation. A minimum protection rating of IP54 in accordance with IEC 60529 is recommended for dust resistance. Control circuits should operate under safe voltage levels below 50 V AC or 120 V DC. Contacts must withstand more than one million operating cycles. Braille markings and illumination with at least 100 lux ensure accessibility for visually impaired users. The emergency stop button must be red and equipped with a reliable spring return mechanism.
