Peugeot 405 Drive Shaft Bearing

Technical Specifications and Dimensions of the Drive Shaft Bearing for Peugeot 405

The clutch bearing, also known as the drive shaft bearing of the Peugeot 405, serves as an intermediary component between the gearbox and the drive shaft. It features precise and standardized specifications that are essential for the proper functioning of the power transmission system.

This bearing is typically a deep groove ball bearing, designed to withstand both axial and radial loads. Choosing a bearing with the correct specifications not only prevents unusual vibrations and noises but also extends the lifespan of the drive shaft and reduces friction between moving parts.

In general, the technical specifications of this component must fully match the type of vehicle and gearbox model to ensure accurate installation and optimal performance.

Standard dimensions of the Peugeot 405 drive shaft bearing typically include:

Inner Diameter: approx. 35 mm

Outer Diameter: approx. 72 mm

Width: approx. 17 mm

Material: High-strength hardened steel

Seal Type: Rubber or metal seal depending on the model

Resistance: Heat and side-load resistant

These specifications may slightly vary depending on the manufacturer or specific trim of your vehicle. For an accurate and confident purchase, it is recommended to consult with the experienced specialists at Roll Pars. Their expert guidance can help you choose the most suitable bearing for your Peugeot 405 and avoid any unnecessary expenses or incorrect orders.